Debug Rip - Allied Telesis SwitchBlade x908 Series Software Reference Manual

RIP Commands

debug rip

Use this command to specify the options for the displayed debugging information for RIP
events and RIP packets.
Use the no parameter with this command to disable the specified debug option.
Syntax
debug rip {events|nsm|<packet>|all}
no debug rip {events|nsm|<packet>|all}
Parameter
events
nsm
<packet>
recv
send
detail
all
Disabled
Default
Privileged Exec mode and Global Configuration mode
Mode
The following example displays information about the RIP packets that are received and sent
Examples
out from the device.
default-information originate
Use this command to generate a default route into the Routing Information Protocol (RIP).
Use the no parameter with this command to disable this feature.
Syntax
default-information originate
no default-information originate
Disabled
Default
Router mode
Mode
Examples
awplus(config-router)#
32.4
Description
RIP events debug information is displayed.
RIP and NSM communication is displayed
packet [recv|send] [detail] Specifies RIP packets only
Specifies that information for received packets be displayed.
Specifies that information for sent packets be displayed.
Displays detailed information for the sent or received packet.
Displays all RIP debug information.
awplus# debug rip packet
awplus#
awplus(config)#
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
configure terminal
router rip
default-information originate
C613-50007-01 REV B