Ip Rip Authentication Key-Chain - Allied Telesis SwitchBlade x908 Series Software Reference Manual

RIP Commands

ip rip authentication key-chain

Use this command to enable RIPv2 authentication on an interface and specify the name of the
key chain to be used.
Use the no parameter with this command to disable this function.
Syntax
ip rip authentication key-chain <key-chain-name>
no ip rip authentication key-chain
Parameter
<key-chain-name>
Interface mode
Mode
Use this command to perform authentication on the interface. Not configuring the key chain
Usage
results in no authentication at all.
The AlliedWare Plus
single key or multiple keys at different times. Use the
single key authentication. Use the
authentication. See
For multiple keys authentication, use the following steps to configure a route to enable RIPv2
authentication using multiple keys at different times:
Step 1:
In the Configure mode, identify a key chain with a key chain name using the following
command:
where
spaces.
Step 2:
In the Keychain mode, specify a key on this key chain using the following command:
where
number.
Step 3:
In the Keychain-key mode, define the password used by a key, using the following command:
awplus(config-keychain-key)#
where
password by the key.
32.8
Description
Specify the name of the key chain. This is an alpha-numeric string, but
it cannot include spaces
TM
implementation provides the choice of configuring authentication for
Chapter 31, RIP Configuration
Define a key chain:
awplus(config)#
<key-chain-name>
Define the key or keys:
awplus(config-keychain)#
(a decimal number in the range 1 to 2147483647) is the Key Identifier
<keyid>
Define the authentication string or password:
is a string of characters that can contain spaces, to be used as a
<key-password>
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
ip rip authentication string
ip rip authentication key-chain
for illustrated RIP configuration examples.
key chain <key-chain-name>
is the name of the chain to manage, and should not include
key <keyid>
key-string <key-password>
command for
command for multiple keys
C613-50007-01 REV B