Enabling OSPF on an Interface
This example shows the minimum configuration required for enabling OSPF on an interface. In
this example, the OSPF routers are Allied Telesis managed Layer 3 switches. Switch 1 and
Switch 2 are two OSPF routers in Area 0 connecting to network 10.10.10.0/24.
Note:
Switch 1
awplus#configure terminal
awplus(config)#router ospf 100
awplus(config-router)#network 10.10.10.0/24
area 0
C613-50007-01 REV B
Configure one interface so that it belongs to only one area. However, you can
configure different interfaces on an OSPF router to belong to different areas.
AS1
Area 0
10.10.10.10/24
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus
Operating System - Software Version 5.3.1
Switch 2
10.10.10.11/24
Switch 1
Enter the Configure mode.
Configure the Routing process and specify the Process
ID (100). The Process ID should be a unique positive
integer identifying the routing process.
Define the interface (10.10.10.0/24) on which OSPF
runs and associate the area ID (0) with the interface
(area ID 0 specifies the backbone area).
OSPF Configuration
ospf_1
35.3