bandwidth
Use this command to specify the maximum bandwidth to be used for each interface.
The bandwidth value is in bits. OSPF uses this to calculate metrics for the interface.
The no form removes the maximum bandwidth.
Syntax
bandwidth
no bandwidth
Parameter
<bandwidth-setting>
Interface mode
Mode
Examples
show running-config
Related Commands
show running-config access-list
show interface
capability opaque
This command enables opaque-LSAs. Opaque-LSAs are Type 9, 10 and 11 LSAs that deliver
information used by external applications.
By default, opaque-LSAs are enabled.
The no form of this command to disables opaque-LSAs.
Syntax
capability opaque
no capability opaque
Router mode
Mode
Examples
awplus(config-router)#
C613-50007-01 REV B
<bandwidth-setting>
awplus#
configure terminal
awplus(config)#
interface port1.0.2
awplus(config-if)#
bandwidth 1000000
awplus#
configure terminal
awplus(config)#
router ospf 100
no capability opaque
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus
Operating System - Software Version 5.3.1
Description
Sets to bandwidh for the interface. Enter a value in the
range 1 to 10000000000 bits.
OSPF Commands
36.13