Network Synchronization - Allied Telesis SwitchBlade x908 Series Software Reference Manual

The following example illustrates a network address which does not fall into its natural class
boundary, and hence, is perceived as a host route, that is, 1.2.3.0/32.
awplus(config-router)#
awplus(config-router)#

network synchronization

Use this command to ensure the exact same static network prefix, specified through any of the
network
introduced into the BGP RIB.
Use the no parameter with this command to disable this function.
Syntax
network synchronization
no network synchronization
Network synchronization is disabled by default.
Default
Router mode and Address Family [ipv4 unicast] mode
Mode
The following example enables IGP synchronization of BGP static network routes in the router
Example
configuration mode.
awplus(config-router)#
The following example enables IGP synchronization of BGP static network routes in the IPv4-
Unicast address family.
awplus(config-af)#
C613-50007-01 REV B
awplus(config)#
awplus(config)#
awplus#
router bgp 1
no synchronization
network 1.2.3.0 mask 255.255.255.255
< prefix > commands, is local or has IGP reachability (in the NSM RIB) before being
awplus#
awplus(config)#
awplus# configure terminal
awplus(config)# router bgp 11
awplus(config)# address-family ipv4 unicast
network synchronization
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
router bgp 1
network 1.2.3.0
exit
exit
show run
configure terminal
router bgp 11
network synchronization
BGP Commands
38.97