Tunnel Source - Allied Telesis SwitchBlade x908 Series Software Reference Manual

tunnel source

tunnel source Command
Use this command to specify the IPv4 source address for packets being encapsulated in the
tunnel. It should be the IPv4 address on the interface that attaches the switch for the IPv4
domain through which the IPv6 packets are to be tunneled.
Use the no parameter to remove a tunnel source address for a tunnel interface.
Syntax
tunnel source <ipv4-address>
no tunnel source
Parameter
<ipv4-address>
Interface mode
Mode
This command specifies an IPv4 source address for the tunnel.
Usage
Note:
Example
interface tunnel
Related Commands
tunnel dscp
tunnel mode ipv6ip
tunnel ttl
C613-50007-01 REV B
New vs_531 %flag
Description
IPv4 tunnel source address in format
There are constraints on the IPv4 source address specified for the tunnel. The IPv4
source address for the tunnel must be the IPv4 address of an interface on the switch,
and it must be the interface for carrying the tunnel traffic.
awplus# configure terminal
awplus(config)# interface tunnel 100
awplus(config-if)# tunnel source 10.11.2.1
awplus# configure terminal
awplus(config)# interface tunnel 100
awplus(config-if)# no tunnel source
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
IPv6to4 Tunneling Commands Use this command to specify the IPv4 source address for packets being encapsulated in the tunnel.
A.B.C.D
IPv6to4 Tunneling Commands
27.5