Neighbor Unsuppress-Map - Allied Telesis SwitchBlade x908 Series Software Reference Manual

BGP Commands

neighbor unsuppress-map

Use this command to selectively leak more-specific routes to a particular neighbor.
Use the no neighbor unsuppress-map command to remove selectively leaked specific
routes to a particular neighbor as specified previously with the neighbor unsuppress-map
command.
Syntax
neighbor <neighborid> unsuppress-map <route-map-name>
no neighbor <neighborid> unsuppress-map <route-map-name>
Parameter
<neighborid>
<route-map-
name>
Router mode and Address Family [ipv4 unicast|ipv4 multicast] mode
Mode
When the aggregate-address command is used with the summary-only option, the
Usage
more-specific routes of the aggregate are suppressed to all neighbors. Use the unsuppress-
map command to selectively leak more-specific routes to a particular neighbor.
Example
awplus(config-router)#
awplus(config-router-af)#
38.92
Description
{<ip-address>|<tag>}
<ip-
address>
<tag>
The name of the route-map used to select routes to be unsuppressed.
awplus# configure terminal
awplus(config)# router bgp 10
neighbor 10.10.0.73 unsuppress-map mymap
awplus#
awplus(config)#
awplus(config-router)#
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
The address of an IPv4 BGP neighbor, in dotted
decimal notation A.B.C.D.
Name of an existing peer-group. For information on
how to create peer groups, refer to the
peer-group (adding a neighbor) command on
page 38.75, and neighbor remote-as command
on page 38.79. When this parameter is used with a
command, the command applies on all peers in the
specified group.
configure terminal
router bgp 10
address-family ipv4 unicast
neighbor 10.10.0.70 unsuppress-map mymap
neighbor
C613-50007-01 REV B