Match Route-Type - Allied Telesis SwitchBlade x908 Series Software Reference Manual

match route-type

Use this command to add an external route-type match clause to a route map entry. Specify
whether to match OSPF type-1 external routes or OSPF type-2 external routes.
An OSPF route matches the route map if its route type matches the route map's route type.
Each entry of a route map can only match against one route type in one match clause. If the
route map entry already has a route type match clause, entering this command replaces that
match clause with the new clause.
Use the no parameter to remove the route type match clause from the route map entry.
Syntax
match route-type external {type-1|type-2}
no match route-type external [type-1|type-2]
Parameter
type-1
type-2
Route-map mode
Mode
Use the match route-type external command to match specific external route types. AS-
Usage
external LSA is either Type-1 or Type-2. external type-1 matches only Type 1 external
routes, and external type-2 matches only Type 2 external routes.
This command is valid for OSPF routes only.
To add entry 10 to the route map called mymap1, which will process type-1 external routes,
Examples
use the commands:
awplus(config-route-map)#
match interface
Related Commands
match ip address
match ip next-hop
match tag
route-map
set metric-type
show route-map
C613-50007-01 REV B
Description
OSPF type-1 external routes
OSPF type-2 external routes
awplus#
awplus(config)#
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
configure terminal
route-map mymap1 permit 10
match route-type external type-1
Route Map Commands
39.15