Default Log Monitor; Default Log Permanent - Allied Telesis SwitchBlade x908 Series Software Reference Manual

Logging Commands

default log monitor

Restores the default settings for log messages sent to the terminal when a terminal monitor
command is issued. By default all messages are sent to the terminal when a terminal
monitor command is issued.
Syntax
default log monitor
Parameter
default
log
monitor
Global Configuration mode
Mode
All messages are sent to the terminal when a terminal monitor command is issued.
Default
To restore the log monitor to its default settings use the command:
Examples
awplus(config)#
show exception log
Related Commands
log monitor (filter)
show log config

default log permanent

Restores the default settings for the permanent log stored in NVS. By default, the size of the
permanent log is 50 kB and it accepts messages with the severity level of warnings and above.
The permanent log is enabled by default.
Syntax
default log permanent
Parameter
default
log
permanent
Global Configuration mode
Mode
To restore the permanent log to its default settings use the command:
Examples
awplus(config)#
log permanent
Related Commands
log permanent size
show log config
10.8
Description
Restore default settings
Logging control
Store log messages permanently in NVS
default log monitor
Description
Restore default settings
Logging control
Store log messages permanently in NVS
default log permanent
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1 C613-50007-01 REV B