Timers (Ipv) - Allied Telesis SwitchBlade x908 Series Software Reference Manual

timers (IPv6)
timers (IPv6) Command
Use this command to adjust the RIPng routing network timers.
Use the no parameter with this command to restore the defaults.
Syntax timers basic <update> <timeout> <garbage>
no timers basic
Parameter
<update>
<timeout>
<garbage>
Router mode
Mode
The default RIPng routing table update timer default is 30 seconds, the default RIPng routing
Default
information timeout timer is 180 seconds, and the default RIPng routing garbage collection
timer is 120 seconds. The no timers basic command restores the default RIPng routing
timers.
Example
awplus(config-router)#
C613-50007-01 REV B
New vs_531 %flag
Description
<5-2147483647>
seconds. The default is 30 seconds.
<5-2147483647>
timer in seconds. The default is 180 seconds. After this interval has elapsed
and no updates for a route are received, the route is declared invalid.
<5-2147483647>
timer in seconds. The default is 120 seconds.
awplus# configure terminal
awplus(config)# router ipv6 rip
timers basic 30 180 120
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
RIPng Commands Use this command to adjust the RIPng routing network timers.
Specifies the RIPng routing table update timer in
Specifies the RIPng routing information timeout
Specifies the RIPng routing garbage collection
RIPng Commands
34.19