Chapter 4. Cli Navigation Commands; Introduction; Configure Terminal; Disable - Allied Telesis SwitchBlade x908 Series Software Reference Manual

CLI Navigation Commands

Introduction

This chapter provides an alphabetized reference for the commands used to navigate between
different modes. This chapter also provides a reference for the help and show commands used
to help navigate within the CLI.

configure terminal

This command enters the configure command mode.
Syntax configure terminal
Privileged Exec mode
Mode
The following example shows the use of the configure terminal command to enter
Examples
the Configure command mode (note the change in the command prompt).

disable

This command exits the Privileged Exec mode, returning the prompt to the Exec mode. To
end a session, use the
Syntax
disable
Privileged Exec mode
Mode
Examples
enable
Related Commands
end
exit
4.2
awplus# configure terminal
awplus(config)#
exit command.
awplus# disable
awplus# >
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1 C613-50007-01 REV B