Match Interface - Allied Telesis SwitchBlade x908 Series Software Reference Manual

match interface

Use this command to add an interface match clause to a route map entry. Specify the interface
name to match.
A route matches the route map if its interface matches the interface name.
Each entry of a route map can only match against one interface in one interface match clause. If
the route map entry already has an interface match clause, entering this command replaces that
match clause with the new clause.
Use the no parameter to remove the interface match clause from the route map entry.
Syntax
match interface <interface>
no match interface
Parameter
<interface>
Route-map mode
Mode
This command is valid for RIP and OSPF routes only.
Usage
To add entry 10 to the route map called mymap1, which will process routes if they use the
Example
interface vlan1, use the commands:
awplus(config-route-map)#
match ip address
Related Commands
match ip next-hop
match route-type
match tag
route-map
show route-map
C613-50007-01 REV B
Description
The VLAN to match, e.g. vlan2.
awplus#
awplus(config)#
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
configure terminal
route-map mymap1 permit 10
match interface vlan1
Route Map Commands
39.5