Neighbor Capability Route-Refresh - Allied Telesis SwitchBlade x908 Series Software Reference Manual

neighbor capability route-refresh

Use this command to advertise route-refresh capability to the specified neighbors.
Use the no parameter with this command to disable this function
Syntax
neighbor <neighborid> capability route-refresh
no neighbor <neighborid> capability route-refresh
Parameter
<neighborid>
Router mode
Mode
Use this command to advertise to peer about route refresh capability support. If route refresh
Usage
capability is supported, then router can dynamically request that the peer readvertises its
Adj-RIB-Out.
Example
awplus(config-router)#
C613-50007-01 REV B
Description
{<ip-address>|<tag>}
<ip- The address of an IPv4 BGP neighbor, in dotted decimal
address>
notation A.B.C.D.
<tag> Name of an existing peer-group. For information on how to
create peer groups, refer to the
(adding a neighbor) command on page
neighbor remote-as command on page
this parameter is used with a command, the command applies
on all peers in the specified group.
awplus# configure terminal
awplus(config)# router bgp 10
neighbor 10.10.10.1 capability route-refresh
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
BGP Commands
neighbor peer-group
38.75, and
38.79. When
38.61