Set Local-Preference - Allied Telesis SwitchBlade x908 Series Software Reference Manual

set local-preference

This command changes the default local preference value.
The local preference indicates the BGP local preference path attribute when there are multiple
paths to the same destination. The path with the higher preference is chosen. Use this
command to define the preference of a particular path. The preference is sent to all routers
and access servers in the local autonomous system.
The no form reverts to the default setting.
Syntax set local-preference <pref-value>
no set local-preference [<pref-value>]
Parameter
<pref-value>
Router mode
Mode
Examples
awplus(config-route-map)#
awplus(config-route-map)#
route-map
Related Commands
show route-map
For BGP:
bgp default local-preference
neighbor route-map
C613-50007-01 REV B
Description
<0-4294967295> Configure local preference value. The default local
preference value is 100.
awplus#
awplus(config)#
awplus#
awplus(config)#
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
configure terminal
route-map rmap1 permit 3
set local-preference 2345555
configure terminal
router bgp 100
no set local-preference
Route Map Commands
39.31