Neighbor Weight - Allied Telesis SwitchBlade x908 Series Software Reference Manual

neighbor weight

Use this command to set default weights for routes from this neighbor.
Use the no parameter with this command to remove a weight assignment.
Syntax
neighbor <neighborid> weight <weight>
no neighbor <neighborid> weight [<weight>]
Parameter
<neighborid>
<weight>
Router mode
Mode
Use this command to specify a weight value to all routes learned from a neighbor. The route
Usage
with the highest weight gets preference when there are other routes on the network.
Unlike the local-preference attribute, the weight attribute is relevant only to the local router.
The weights assigned using the set weight command overrides the weights assigned using this
command.
Example
awplus(config-router)#
C613-50007-01 REV B
Description
{<ip-address>|<tag>}
<ip-
address>
<tag>
<0-65535> Specifies the weight this command assigns to the route.
awplus# configure terminal
awplus(config)# router bgp 12
neighbor 10.10.10.10 weight 60
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
The address of an IPv4 BGP neighbor, in dotted decimal
notation A.B.C.D.
Name of an existing peer-group. For information on how
to create peer groups, refer to the
group (adding a neighbor) command on page
38.75, and neighbor remote-as command on
page 38.79. When this parameter is used with a
command, the command applies on all peers in the
specified group.
BGP Commands
neighbor peer-
38.95