Host Area - Allied Telesis SwitchBlade x908 Series Software Reference Manual

host area

This command configures a stub host entry belonging to a particular area. You can use this
command to advertise specific host routes in the router-LSA as stub link. Since stub host
belongs to the specified router, specifying cost is optional.
By default, no host entry is configured.
The no form of this command removes the host area configuration.
Syntax
host <ip-address> area <area-id> [cost <0-65535>]
no host <ip-address> area <area-id> [cost <0-65535>]
Parameter
<ip-address>
<area-id>
cost <0-65535>
Router mode
Mode
Examples
awplus(config-router)#
awplus(config-router)#
C613-50007-01 REV B
Description
The IPv4 address of the host, in dotted decimal notation.
The area ID of the transit area that configuring the stub host entry
for. Use one of the following formats: This can be entered in either
dotted decimal format or normal decimal format. For example the
values dotted decimal 0.0.1.2 and decimal 258 would both define
the same area ID.
<ip-address>
<0-4294967295>
The cost for the stub host entry.
awplus# configure terminal
awplus(config)# router ospf 100
host 172.16.10.100 area 1
host 172.16.10.101 area 2 cost 10
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
OSPF Area ID expressed in IPv4 address
format .
A.B.C.D
OSPF Area ID expressed as a decimal
number within the range shown
OSPF Commands
36.27