Switchport Trunk Allowed Vlan - Allied Telesis SwitchBlade x908 Series Software Reference Manual

VLAN Commands

switchport trunk allowed vlan

Use this command to add VLANs to be trunked over this switch port. Traffic for these VLANs
can be sent and received on the port.
The all parameter sets the port to be a tagged member of all the VLANs configured on the
device. The none parameter removes all VLANs from the port's tagged member set. The add
and remove parameters will add and remove VLANs to and from the port's member set.
Syntax switchport trunk allowed vlan all
switchport trunk allowed vlan none
switchport trunk allowed vlan add <vid-list>
switchport trunk allowed vlan remove <vid-list>
switchport trunk allowed vlan except <vid-list>
Parameter
all
none
add
remove
except
<vid-list>
By default, ports are untagged members of the default VLAN (vlan1).
Default
Interface mode
Mode
The following shows adding a single VLAN to the port's member set.
Examples
awplus(config-if)#
17.14
Description
Allow all VLANs to transmit and receive through the port.
Allow no VLANs to transmit and receive through the port.
Add a VLAN to transmit and receive through the port.
Remove a VLAN from transmit and receive through the port.
All VLANs, except the VLAN for which the VID is specified, are part of its
port member set.
<2-4094> The ID of the VLAN or VLANs that will be added to, or
removed from, the port. A single VLAN, VLAN range, or comma-
separated VLAN list can be set.
For a VLAN range, specify two VLAN numbers: lowest, then highest
number in the range, separated by a hyphen.
For a VLAN list, specify the VLAN numbers separated by commas.
Do not enter spaces between hyphens or commas when setting
parameters for VLAN ranges or lists.
awplus# configure terminal
awplus(config)# interface port1.0.2
switchport trunk allowed vlan add 2
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1 C613-50007-01 REV B