Ip Local-Proxy-Arp - Allied Telesis SwitchBlade x908 Series Software Reference Manual

Switchblade x908/x900 series alliedware plus operating system software reference for version 5.3.1
Hide thumbs Also See for SwitchBlade x908 Series:
Table of Contents

Advertisement

IP Addressing and Protocol Commands

ip local-proxy-arp

This command allows you to stop MAC address resolution between hosts within a private
VLAN edge interface. Local Proxy ARP works by intercepting ARP requests between hosts
within a subnet and responding with your device's own MAC address details instead of the
destination host's details. This stops hosts from learning the MAC address of other hosts within
its subnet through ARP requests.
Local Proxy ARP ensures that devices within a subnet cannot send traffic that bypasses layer 3
routing on your device. This lets you monitor and filter traffic between hosts in the same
subnet, and enables you to have control over which hosts may communicate with one another.
When Local Proxy ARP is operating on an interface, your device does not generate or forward
any ICMP-Redirect messages on that interface. This command does not enable proxy ARP on
the interface; see the
The no form disables Local Proxy ARP to stop your device from intercepting and responding
to ARP requests between hosts within a subnet. This allows the hosts to use MAC address
resolution to communicate directly with one another. Local Proxy ARP is disabled by default.
Syntax
ip local-proxy-arp
no ip local-proxy-arp
Interface mode
Mode
Local proxy ARP is disabled by default
Default
To enable your device to apply Local Proxy ARP on the interface vlan7, use the following
Examples
commands:
To disable your device to apply Local Proxy ARP on the interface vlan7, use the following
commands:
ip proxy-arp
Related Commands
show arp
show running-config
23.26
ip proxy-arp
awplus#
configure terminal
awplus(config)#
interface vlan7
awplus(config-if)#
ip local-proxy-arp
awplus#
configure terminal
awplus(config)#
interface vlan7
awplus(config-if)#
no ip local-proxy-arp
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus
Operating System - Software Version 5.3.1
command for more information on enabling proxy ARP.
C613-50007-01 REV B

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents