Switchport Mode Access - Allied Telesis SwitchBlade x908 Series Software Reference Manual

switchport mode access

Use this command to set the switching characteristics of the port to access mode. Received
frames are classified based on the VLAN characteristics, then accepted or discarded based on
the specified filtering criteria.
Syntax
switchport mode access [ingress-filter {enable|disable}]
Parameter
ingress-filter
enable
disable
By default, ports are in access mode with ingress filtering on.
Default
Use access mode to send untagged frames only.
Usage
Interface mode
Mode
Examples
awplus(config-if)#
C613-50007-01 REV B
Description
Set the ingress filtering for the received frames.
Turn on ingress filtering for received frames. This is the default value
Turn off ingress filtering to accept frames that do not meet the
classification criteria.
awplus# configure terminal
awplus(config)# interface port1.0.2
switchport mode access ingress-filter enable
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
VLAN Commands
17.9