Clear Ip Bgp External - Allied Telesis SwitchBlade x908 Series Software Reference Manual

clear ip bgp external

Use this command to reset the BGP connections to all external peers.
Syntax clear ip bgp external [<in>|out|<soft>]
clear ip bgp external ipv4 <prefix> <routes>
Parameter
external
ipv4
<routes>
<in>
in
prefix-filter
out
<soft>
in
out
<prefix>
unicast
multicast
Privileged Exec mode
Mode
Example
awplus#
awplus#
C613-50007-01 REV B
Description
Clears all external peers
Clears all IPv4 address family peers. Configure parameters relating to the
BGP exchange of IPv4 prefixes.
{<in>|out|soft}
in [prefix-filter]
Indicates that incoming advertised routes will be cleared
Specifies that a prefix-list will be sent, by the ORF mechanism, to those
neighbors with which the ORF capability has been negotiated. The
neighbors will be triggered to resend updates, which match the prefix-list
filter, to the local router. The local router will then perform a soft
reconfiguration.
Indicates that outgoing advertised routes will be cleared.
soft [in |out]
Soft inbound reset causes the neighbors to resend all their updates to the
local switch, without resetting the connection or clearing the entries in the
local switch. So, the local switch stores new updates, and uses them to
systematically replace existing table entries. This process can use a
considerable amount of memory.
Soft outbound reset causes the switch to simply resend all its updates to
the specified neighbor(s), without resetting the connection, or clearing
table entries.
{unicast|multicast}
unicast address family modifier. Configure parameters relating to the BGP
exchange of routes to unicast destinations.
multicast address family modifier. Configure parameters relating to the
BGP exchange of routes to multicast sources.
clear ip bgp external out
clear ip bgp external ipv4 unicast in prefix-filter
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
BGP Commands
38.41