Show Interface - Allied Telesis SwitchBlade x908 Series Software Reference Manual

show interface

Use this command to display interface configuration and status.
Syntax show interface [<interface-list>]
Parameter
<interface-
list>
Exec mode and Privileged Exec mode
Mode
Figure 12-1: Example output from the
Output
Interface port1.0.1
Scope: both
Link is UP, administrative state is UP
Thrash-limiting
Status Not Detected, Action link-down, Timeout 60(s)
Hardware is Ethernet, address is 0000.cd24.daeb (bia 0000.cd24.daeb)
VRRP Master of :
index 5001 metric 1 mtu 1500
duplex-full speed 1000 polarity auto
<UP,BROADCAST,RUNNING,MULTICAST>
VRF Binding: Not bound
Bandwidth 1g
input packets 2396, bytes 324820, dropped 0, multicast packets 2370
output packets 73235, bytes 4906566, multicast packets 73218 broadcast packets 7
C613-50007-01 REV B
Description
The interfaces or switch ports to display information about. An interface-
list can be:
an interface, a switch port, or a channel group (e.g., vlan2, port1.1.12,
■
sa3, or po4)
a continuous range of interfaces, switch ports, or channel groups
■
separated by a hyphen, e.g. vlan2-vlan8 or port1.1.1-port1.1.24 or
sa2-4, po1-3
a comma-separated list of the above.
■
The specified interfaces must exist.
VRRP is not configured on this interface.
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
show interface command
Interface Commands
12.5