Network Area - Allied Telesis SwitchBlade x908 Series Software Reference Manual

network area

Use this command to enable OSPF routing with a specified Area ID on interfaces with IP
addresses that match the specified network address.
Use the no parameter with this command to disable OSPF routing on the interfaces.
Syntax
network <network_address> area <area_id>
no network <network_address> area <area_id>
Parameter
<network_address>
<ip-network/m>
<ip-address>
<reverse-mask>
<area_id>
<ip-address>
<0-4294967295>
No network area is configured.
Default
Router mode
Mode
OSPF routing can be enabled per IPv4 subnet. The network address can be defined using either
Usage
the prefix length or a wild card mask. A wild card mask is comprised of consecutive 0's as
network bits and consecutive 1's as host bits.
Examples
awplus(config-router)#
awplus(config-router)#
C613-50007-01 REV B
Description
{<ip-network/m>|<ip-address> <reverse-mask>}
IP adress of the network, entered in the form
dotted decimal notation followed by a forward slash, and then
the subnet mask length.
IPv4 network address, entered in the form
Reverse mask in dotted decimal format.
Note that the term reverse-mask is sometimes referred to as a
Wildcard mask.
{<ip-address>|<0-4294967295>}
OSPF Area ID in IPv4 address format, in the form A.B.C.D.
OSPF Area ID as 4 octets unsigned integer value.
awplus# configure terminal
awplus(config)# router ospf 100
network 10.0.0.0/8 area
network 10.0.0.0/8 area 1.1.1.1
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
OSPF Commands
:
A.B.C.D/M
.
A.B.C.D
3
36.45