Ip Rip Send-Packet; Ip Rip Send Version - Allied Telesis SwitchBlade x908 Series Software Reference Manual

ip rip send-packet

Use this command to enable sending RIP packets through the current interface.
Use the no parameter with this command to disable this feature.
Syntax
ip rip send-packet
no ip rip send-packet
Send packet is enabled
Default
Interface mode
Mode
This example shows packet sending being turned on for interface VLAN4.
Example
ip rip receive-packet
Related Commands

ip rip send version

Use this command to specify the version of RIP packets sent on an interface and override the
setting of the version command.
Use the no form of this command to use the setting specified by the version command.
Syntax
ip rip send version {[1][2]}
no ip rip send version
Parameter
1
2
Version 2
Default
Interface mode
Mode
This command applies to a specific interface and overrides any the version specified by the
Usage
version command.
In the following example, interface VLAN4 is configured to send both RIP version 1 and 2
Example
packets.
awplus(config-if)#
C613-50007-01 REV B
awplus#
awplus(config)#
awplus(config-if)#
Description
Specifies sending of RIP version 1 packets out of an interface.
Specifies sending of RIP version 2 packets out of an interface.
awplus# configure terminal
awplus(config)# interface VLAN4
ip rip send version 1 2
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
configure terminal
interface VLAN4
ip rip send-packet
RIP Commands
32.17