Link Aggregation Commands
lacp port-priority
Sets the priority of a switch port. Ports are selected for aggregation based on their priority, with
the higher priority (numerically lower) ports selected first.
Use the no parameter with this command to reset the priority of port to the default value
(32768).
Syntax
lacp port-priority <1-65535>
no lacp port-priority
Parameter
<1-65535>
Interface mode
Mode
Example
lacp system-priority
Use this command to set the system priority of a local system. This is used in determining the
system responsible for resolving conflicts in the choice of aggregation groups.
Use the no parameter with this command to reset the system priority of the local system to
the default value (32768).
Syntax
lacp system-priority <1-65535>
no lacp system-priority
Parameter
<1-65535>
Global Configuration mode
Mode
Example
21.6
Description
Specify the LACP port priority.
awplus#
configure terminal
awplus(config)#
interface port1.2.5
awplus(config-if)#
lacp port-priority 34
Description
LACP system priority. The default system priority is 32768. Lower
numerical values have higher priorities.
awplus# configure terminal
awplus(config)# lacp system-priority 6700
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus
Operating System - Software Version 5.3.1
C613-50007-01 REV B