Ipv6 Router Rip - Allied Telesis SwitchBlade x908 Series Software Reference Manual

RIPng Commands

ipv6 router rip

ipv6 router rip Command
Use this command to enable RIPng routing on the interface.
Use the no parameter with this command to disable RIPng routing.
Syntax ipv6 router rip
no ipv6 router rip
Disabled
Default
Interface mode
Mode
Example
awplus(config-if)#
awplus(config-if)#
34.8
New vs_531 %flag
awplus# configure terminal
awplus(config)# interface vlan2
ipv6 router rip
awplus# configure terminal
awplus(config)# interface vlan2
no ipv6 router rip
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
RIPng Commands Use this command to enable RIPng routing on the interface.
C613-50007-01 REV B