Boot Backup; Boot Config-File - Allied Telesis SwitchBlade x908 Series Software Reference Manual

File Management Commands

boot backup

This command specifies a backup release file to load during the next boot cycle. If your device
cannot load the main release file, then the file specified with this command is used.
Syntax
boot backup <filename>
Parameter
<filename>
Global Configuration mode
Mode
To set the release file r1-5.3.1.rel as the device's backup release, use the command:
Examples

boot config-file

Related Commands
boot system
show boot
boot config-file
This command sets the configuration file to use during the next boot cycle.
Syntax
boot config-file <filename>
Parameter
<filename>
Global Configuration mode
Mode
To run the configuration file branch.cfg the next time the device boots up, use the
Examples
command:
boot backup
Related Commands
boot system
show boot
7.4
Description
Name of a release file. The specified file must exist in the root
directory of the flash file system. Valid release files must have a .rel
extension.
awplus(config)#boot backup rl-5.3.1.rel
Description
Name of a configuration file. The specified file must exist in the
root directory of the flash file system. Valid configuration files must
have a .cfg extension.
awplus(config)#boot config-file flash:/branch.cfg
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1 C613-50007-01 REV B