Log Buffered (Filter) - Allied Telesis SwitchBlade x908 Series Software Reference Manual

log buffered (filter)

Use this command to create a filter to select messages to be sent to the buffered log. Selection
can be based on the priority/ severity of the message, the program that generated the message,
the logging facility used, a sub-string within the message or a combination of some or all of
these.
The no version of the command removes the corresponding filter, so that the specified
messages are no longer sent to the buffered log.
By default the buffered log has a filter to select messages whose severity level is "notices (5)" or
higher. This filter may be removed using the no form of this command.
Syntax
log buffered
no log buffered
Parameter
log
buffered
no
level
<level>
C613-50007-01 REV B
[level <level>]
[program <program-name>]
[facility <facility>]
[msgtext <text-string>]
[level <level>]
[program <program-name>]
[facility <facility>]
[msgtext <text-string>]
Description
Logging control
Store log messages in a RAM buffer
Deletes the specified filter, so that corresponding messages are no
longer sent to the buffered log.
Filter messages to the buffered log by severity level.
The minimum severity of message to send to the buffered log. The
level can be specified as one of the following numbers or level names,
where 0 is the highest severity and 7 is the lowest severity:
0 emergencies:
1 alerts
2 critical
3 errors
4 warnings
5 notices
6 informational
7 debugging
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
System is unusable
Action must be taken immediately
Critical conditions
Error conditions
Warning conditions
Normal, but significant, conditions
Informational messages
Debug-level messages
Logging Commands
10.11