Switchport Mode Private-Vlan - Allied Telesis SwitchBlade x908 Series Software Reference Manual

VLAN Commands

switchport mode private-vlan

Use this command to make a layer 2 port as private-vlan host port or promiscuous port.
Use the no form of this command to remove the configuration.
Syntax
switchport mode private-vlan {host|promiscuous}
no switchport mode private-vlan {host|promiscuous}
Parameter
host
promiscuous
Interface mode
Mode
Example
awplus(config-if)#
awplus(config-if)#
awplus(config-if)#
switchport private-vlan mapping
Related Commands
17.10
Description
This port type can communicate with all other host ports assigned to the
same community vlan, but it cannot communicate with the ports in the
same isolated vlan. All communications outside of this vlan must pass
through a promiscuous port in the associated primary vlan.
A promiscuous port can communicate with all interfaces, including the
community and isolated ports within a private VLAN
awplus# configure terminal
awplus(config)# interface port1.0.2
switchport mode private-vlan host
awplus(config)# interface port1.0.3
switchport mode private-vlan promiscuous
awplus(config)# interface port1.0.4
no switchport mode private-vlan promiscuous
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1 C613-50007-01 REV B