Ip Ospf Dead-Interval; Ip Ospf Disable All - Allied Telesis SwitchBlade x908 Series Software Reference Manual

OSPF Commands

ip ospf dead-interval

The dead-interval is the amount of time that OSPF waits to receive an OSPF hello packet from
the neighbor before declaring the neighbor is down. This value is advertised in the router's
hello packets. It must be a multiple of the hello-interval and be the same for all routers on a
specific network.
The no form of this command returns the interval to the default of 40 seconds. If you have
configured this command specifying the IP address of the interface and want to remove the
configuration, specify the IP address (no ip ospf
Syntax
ip ospf [<ip_address>] dead-interval <1-65535>
no ip ospf [<ip_address>] dead-interval
Parameter
<ip_address>
<1-65545>
Interface mode
Mode
The following example shows configuring the dead-interval to 10 seconds on interface vlan1.
Examples
ip ospf hello-interval
Related Commands
show ip ospf interface

ip ospf disable all

This command completely disables OSPF packet processing on an interface. It overrides the
network area
the no ip ospf disable all command to restore OSPF packet processing on a selected
interface.
Syntax
ip ospf disable all
no ip ospf disable all
Interface mode
Mode
Example
36.32
Description
The IPv4 address of the interface, in dotted decimal notation.
The interval in seconds.
Default: 40
awplus# configure terminal
awplus(config)# interface vlan1
awplus(config-if)# ip ospf dead-interval 10
command and disables the processing of packets on the specific interface. Use
awplus# configure terminal
awplus(config)# interface VLAN2
awplus(config-if)# ip ospf disable all
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
dead-interval).
<ip_address>
C613-50007-01 REV B