Neighbor Version - Allied Telesis SwitchBlade x908 Series Software Reference Manual

BGP Commands

neighbor version

Use this command to configure the switch to accept only a particular BGP version.
Use the no parameter with this command to use the default BGP version (version 4).
Syntax
neighbor <neighborid> version <version>
no neighbor <neighborid> version
Parameter
<neighborid>
<version>
4
Router mode
Mode
By default, the system uses BGP version 4 and on request dynamically negotiates down to
Usage
version 2. Using this command disables the router's version-negotiation capability and forces
the router to use only a specified version with the neighbor.
Example
awplus(config-router)#
38.94
Description
{<ip-address>|<tag>}
<ip-
address>
<tag>
{4} Specifies the BGP version number.
Border Gateway Protocol 4
awplus# configure terminal
awplus(config)# router bgp 12
neighbor 10.10.10.10 version 4
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
The address of an IPv4 BGP neighbor, in dotted
decimal notation A.B.C.D.
Name of an existing peer-group. For information on
how to create peer groups, refer to the
peer-group (adding a neighbor) command
on page 38.75, and neighbor remote-as
command on page 38.79. When this parameter
is used with a command, the command applies on
all peers in the specified group.
neighbor
C613-50007-01 REV B