Switchport Port-Security Violation - Allied Telesis SwitchBlade x908 Series Software Reference Manual

switchport port-security violation

Sets the violation action for a switch port. The port action can be either shutdown, restrict
or protect. If shutdown is set, the physical link will be disabled and "shutdown" will be shown
in the config. If restrict is set, the packet from the un-authorized MAC will be discarded and
SNMP TRAP will be generated to alert management. If protect is set, the packet will simply be
discarded by the packet processor silently.
The no switchport port-security violation command sets the violation action to default.
The default violation action is protect.
Syntax
switchport port-security violation {shutdown|restrict|protect}
no switchport port-security violation
Parameter
no
violation
shutdown
restrict
protect
Interface Mode
Mode
To set the action to be shutdown.
Example
awplus(config-if)#
To set the port-security action to the default (protect).
awplus(config-if)#
C613-50007-01 REV B
Description
Negate a command or set its defaults
Action taken when the port exceeds the learning limits
Disable the port
Alert the network administrator
Discard the packet
switchport port-security violation shutdown
no switchport port-security violation
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
Switching Commands
15.43