Set Weight - Allied Telesis SwitchBlade x908 Series Software Reference Manual

set weight

Use this command to add a weight set clause to a route map entry.
The weight value assists in best path selection of BGP routes. It is stored with the route in the
BGP routing table, but is not advertised to peers. When there are multiple routes with a
common destination, the device uses the route with the highest weight value.
When a route matches the route map entry, the device sets its weight to the specified value.
Use the no parameter to remove the set clause.
Syntax
set weight <weight>
no set weight [<weight>]
Parameter
<weight>
Route-map mode
Mode
This command is valid for BGP routes only.
Usage
To use entry 3 of the route map called "rmap1" to give matching routes a weight of 60, use the
Examples
commands:
awplus(config-route-map)#
route-map
Related Commands
show route-map
C613-50007-01 REV B
Description
<0-4294967295>
The weight value.
awplus#
awplus(config)#
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
configure terminal
route-map rmap1 permit 3
set weight 60
Route Map Commands
39.37