Step 3. Check The Interface Is Not A Passive Interface; Step 4. Ensure Ripng Advertisements Get Exchanged - Allied Telesis SwitchBlade x908 Series Software Reference Manual

Step 3. Check the Interface is not a Passive Interface

awplus#show running-config
!
router ipv6 rip
passive interface vlan2
!
awplus#configure terminal
awplus(config)#router ipv6 rip
awplus(config-router)#no passive interface
port1.0.1

Step 4. Ensure RIPng Advertisements get exchanged

awplus#configure terminal
awplus(config)#debug ipv6 rip event
awplus(config)#debug ipv6 rip packet detail
awplus(config)#exit
awplus#terminal monitor
C613-50007-01 REV B
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
Check the interface is not configured as a passive
interface using show running-config command.
passive interface <interface-name>
displays in the config if it is configured to be passive.
Enter the Configure mode.
Enter RIPng Router mode using router ipv6
rip.
Remove the passive interface using the no passive
interface <interface-name> command.
Enter the Configure mode.
Check on the interface to make sure that RIPng
advertisements are being sent and received.
Check on the interface to make sure that RIPng
advertisements are being sent and received.
Exit Configure mode to enter Privileged
Exec mode.
View log messages, or use a packet sniffer such as
Ethereal or Wireshark, to verify RIPng advertisements.
RIPng Configuration
33.5