The Default Configuration Script - Allied Telesis SwitchBlade x908 Series Software Reference Manual

The default configuration script

Most of the above default settings are in the form of commands, which the switch copies to its
running-config when it first boots up.
The switch stores a copy of the default configuration commands in the file, default.cfg and uses
this as its default start-up file.
For more information about start-up files, see
configuration" on page
The following figure shows the contents of the default file.
Contents of default file
!
service password-encryption
!
log record-priority
username manager privilege 15 password 8
$1$bJoVec4D$JwOJGPr7YqoExA0GVasdE0
service telnet
!
ip domain-lookup
!
no ip multicast-routing
!
maximum-paths 8
spanning-tree mode rstp
!
interface eth0
!
interface port1.0.1-1.0.24
switchport
switchport mode access
!
interface vlan1
!
line con 0
line vty 0 32
!
end
C613-50007-01 REV B
1.17.
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
"How to save and boot from the current
Description
An empty comment line (comments begin with an !).
Forces passwords in the script to be encrypted.
Records log message priority.
Specifies the password for the manager user
Turns on the telnet server.
Allows domain name lookups.
Turns off L3 multicast packet switching in the switch
hardware.
Sets maximum number of ECMP routes.
Turns on RSTP.
A heading for any configuration settings for the
management eth0 port. There are no eth0 settings.
Sets each switch port to access mode.
Creates VLAN 1.
A heading for any configuration settings for the console
port. There are no console port settings.
A heading for any configuration settings for VTY
sessions. There are no VTY session settings.
Getting Started
1.15