Ip Forwarding; Ip Forward-Protocol Udp - Allied Telesis SwitchBlade x908 Series Software Reference Manual

ip forwarding

This command enables IP forwarding on your device. When enabled, your device routes IP
packets.
The no form disables IP forwarding on your device. Even when IP forwarding is not enabled,
the device can still work as an IP host; in particular, it can be managed by IP-based applications,
such as SNMP, Telnet and SSH.
Syntax ip forwarding
no ip forwarding
Global Configuration mode
Mode
IP forwarding is enabled by default.
Default
To enable your device to route IP packets, use the command:
Examples
To stop your device from routing IP packets, use the command:
show ip interface brief
Related
Commands

ip forward-protocol udp

ip forward-protocol udp Command
This command enables you to control which UDP broadcasts will be forwarded to the helper
address(es). A UDP broadcast will only be forwarded if the destination UDP port number in
the packet matches one of the port numbers specified using this command.
Refer to the IANA site (www.iana.org) for a list of assigned UDP port numbers for protocols
to forward using ip forward-protocol udp.
C613-50007-01 REV B
awplus(config)# ip forwarding
awplus(config)# no ip forwarding
New vs_531 %flag
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
IP Addressing and Protocol Commands This command enables you to control which UDP broadcasts will be forwarded to the helper address(es).
IP Addressing and Protocol Commands
23.13