Ipv6 Route; Show Ipv6 Forwarding - Allied Telesis SwitchBlade x908 Series Software Reference Manual

IPv6 Commands

ipv6 route

ipv6 route Command
Use this command to establish the distance for static routes of a network prefix. Use the no
form of this command to disable the distance for static routes of the network prefix.
Syntax
ipv6 route <dest-prefix> <dest-prefix/length>
no ipv6 route <dest-prefix> <dest-prefix/length>
Parameter
<dest-prefix/length>
<gateway-ip>
<distvalue>
<gateway-name>
Global Configuration mode
Mode
Examples
awplus(config)#
awplus(config)#
show running-config
Validation
Commands show ipv6 route

show ipv6 forwarding

show ipv6 forwarding Command
Use this command to display IPv6 forwarding status.
Syntax
show ipv6 forwarding
Exec mode and Privileged Exec mode
Mode
Examples
The following is a sample output from this command, displaying the IPv6 forwarding status:
Output
25.12
New vs_531 %flag
{<gateway-ip>|<gateway-name>} [<distvalue>]
{<gateway-ip>|<gateway-name>} [<distvalue>]
awplus# configure terminal
ipv6 route
ipv6 route
New vs_531 %flag
awplus# show ipv6 forwarding
ipv6 forwarding is on
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
IPv6 Commands This new command is used to establish the distance for static routes of a network prefix.
Description
Specifies the IP destination prefix.
The IPv6 address prefix uses the format X:X::/prefix-length;
where prefix-length is a decimal number between 0 and 128.
Specifies the IP gateway (or next hop) address. The IPv6 address
uses the format X:X::X:X/Prefix-Length; where prefix length
represents a decimal number between 0 and 128.
Specifies the administrative distance for the route. Valid values
are from 1 to 255.
Specifies the name of the gateway (or next hop) interface
3ffe3:506::1
128
3ffe:506::1
/128 myintname 32
IPv6 Commands This new command is used to display IPv6 forwarding status.
C613-50007-01 REV B