Ip Rip Receive Version - Allied Telesis SwitchBlade x908 Series Software Reference Manual

RIP Commands

ip rip receive version

Use this command to specify the version of RIP packets accepted on an interface and override
the setting of the version command.
Use the no form of this command to use the setting specified by the version command.
Syntax
ip rip receive version {[1][2]}
no ip rip receive version
Parameter
1
2
Version 2
Default
Interface mode
Mode
This command applies to a specific interface and overrides any the version specified by the
Usage
version command.
In the following example, interface VLAN3 is configured to receive both RIP version 1 and 2
Example
packets.
awplus(config-if)#
version
Related Commands
32.16
Description
Specifies acceptance of RIP version 1 packets on the interface.
Specifies acceptance of RIP version 2 packets on the interface.
awplus# configure terminal
awplus(config)# interface VLAN3
ip rip receive version 1 2
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1 C613-50007-01 REV B