Show Port Etherchannel - Allied Telesis SwitchBlade x908 Series Software Reference Manual

show port etherchannel

Use this command to show LACP details of the switch port specified.
To modify the lines displayed, use the | (output modifier token); to save the output to a file,
use the > output redirection token.
Syntax
show port etherchannel <port>
Parameter
<port>
Privileged Exec mode
Mode
Example
Figure 21-7: Example output from the show port etherchannel command
Output
% Link: port1.0.1 (5001)
% Aggregator: po1 (4501)
% Receive machine state: Current
% Periodic Transmission machine state: Fast periodic
% Mux machine state: Collecting/Distributing
% Actor Information:
% Selected ................ Selected
% Physical Admin Key ............. 1
% Port Key ....................... 5
% Port Priority .............. 32768
% Port Number ..,,,,,.......... 5001
% Mode ...................... Active
% Timeout ..................... Long
% Individual ................... Yes
% Synchronised ................. Yes
% Collecting ................... Yes
% Distributing ................. Yes
% Defaulted .................... Yes
% Expired ....................... No
C613-50007-01 REV B
Description
Name of the switch port to display LACP information about.
awplus# show port etherchannel port1.0.1
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
Partner Information:
Partner Sys Priority ............ 0
Partner System .. 00-00-00-00-00-00
Port Key ........................ 0
Port Priority ................... 0
Port Number ..................... 0
Mode ...................... Passive
Timeout ..................... Short
Individual .................... Yes
Synchronised .................. Yes
Collecting .................... Yes
Distributing .................. Yes
Defaulted ..................... Yes
Expired ........................ No
Link Aggregation Commands
21.13