Show Ip Community-List; Show Ip Protocols Bgp - Allied Telesis SwitchBlade x908 Series Software Reference Manual

show ip community-list

Use this command to display routes that match a specified community-list name or number.
Syntax show ip community-list [<listnumber>|<listname>]
Parameter
<listnumber>
<listname>
Privileged Exec mode and Exec mode
Mode
Example

show ip protocols bgp

Use this command to display BGP process parameters and statistics.
Syntax
show ip protocols bgp
Exec mode and Privileged Exec mode
Mode
To display BGP process parameters and statistics, use the command:
Example
Figure 38-14: Example output from the
Output
Routing Protocol is "bgp 100"
IGP synchronization is disabled
Automatic route summarization is disabled
Default local-preference applied to incoming route is 100
Redistributing:
Neighbor(s):
Address AddressFamily FiltIn FiltOut DistIn DistOut RouteMapIn RouteMapOut Weight
10.10.10.1
C613-50007-01 REV B
Description
Specifies the community list number in the range <1-199>
as specified by a previously issued ip community-list command.
Specifies the community list name as specified by a previously issued |
ip community-list command..
awplus# show ip community-list mylist
awplus# show ip community-list 99
awplus# show ip protocols bgp
unicast
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
show ip protocols bgp command
BGP Commands
38.121