Bgp Client-To-Client Reflection - Allied Telesis SwitchBlade x908 Series Software Reference Manual

bgp client-to-client reflection

This command restores route reflection from a BGP route reflector to clients.
The bgp client-to-client reflection command is used to configure routers as route
reflectors. Route reflectors are used when all Interior Border Gateway Protocol (iBGP)
speakers are not fully meshed. If the clients are fully meshed the route reflector is not required,
use the no bgp client-to-client reflection command to disable the client-to-client route
reflection.
When a router is configured as a route reflector, client-to-client reflection is enabled by default.
The no form turns off client-to-client reflection.
Syntax
bgp client-to-client reflection
no bgp client-to-client reflection
Router mode
Mode
Example
awplus(config-router)#
bgp cluster-id
Related Commands
neighbor route-reflector-client
show ip bgp
C613-50007-01 REV B
awplus# configure terminal
awplus(config)# router bgp 100
no bgp client-to-client reflection
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
BGP Commands
38.11