Copy Startup-Config - Allied Telesis SwitchBlade x908 Series Software Reference Manual

copy startup-config

This command copies the startup-config script into a destination file, or alternatively copies a
configuration script from a source file into the startup-config file. Specify whether the
destination is flash or card when loading from the local file system.
Syntax
copy <source-url> startup-config
copy startup-config <destination-url>
Parameter
<source-url>
<destination-url>
Privileged Exec mode
Mode
To copy the file Layer3.cfg to the startup-config, use the command:
Examples
To copy the startup-config as the file oldconfig.cfg in the current directory, use the
command:
copy running-config
Related Commands
C613-50007-01 REV B
Description
The URL of a configuration file. This must be a valid configuration
file with a .cfg filename extension. Specify this to copy the script
in the file into the startup-config file. Note that this does not make
the copied file the new startup file, so any further changes made in
the configuration file are not added to the startup-config file unless
you reuse this command. See
on page 7.3
The destination and filename that you are saving the startup-config
as. This command creates a file if no file exists with the specified
filename. If a file already exists, then the CLI prompts you before
overwriting the file. See
page 7.3
awplus#copy Layer3.cfg startup-config
awplus#copy startup-config oldconfig.cfg
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
"URL Syntax and Keyword Usage"
for valid URL syntax.
"URL Syntax and Keyword Usage" on
for valid URL syntax.
File Management Commands
7.9