Neighbor Port - Allied Telesis SwitchBlade x908 Series Software Reference Manual

neighbor port

Use this command to specify the TCP port to which packets are sent to on a neighbor.
Syntax neighbor <neighborid> port <portnum>
no neighbor <neighborid> port [<portnum>]
Parameter
<neighborid>
<portnum>
Router mode
Mode
Example
awplus(config-router)#
C613-50007-01 REV B
Description
{<ip-address>|<tag>}
<ip-
address>
<tag>
<0-65535> Specifies the TCP port number.
awplus# configure terminal
awplus(config)# router bgp 12
neighbor 10.10.10.10 port 643
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
The address of an IPv4 BGP neighbor, in dotted decimal
notation A.B.C.D.
Name of an existing peer-group. For information on how
to create peer groups, refer to the
group (adding a neighbor) command on page
38.75, and neighbor remote-as command on page
38.79. When this parameter is used with a command, the
command applies on all peers in the specified group.
BGP Commands
neighbor peer-
38.77