Mac Address-Table Static - Allied Telesis SwitchBlade x908 Series Software Reference Manual

mac address-table static

Use this command to statically configure the MAC address-table to forward or discard frames
with a matching destination MAC address.
Syntax
mac address-table static <mac-addr> {forward|discard} interface
no mac address-table static <mac-addr> {forward|discard} interface
Parameter
<mac-addr>
<port>
<vid>
Global Configuration mode
Mode
The mac address-table static command is only applicable to layer 2 switched traffic within
Usage
a single VLAN. Do not apply the mac address-table static command to layer 3 switched
traffic passing from one VLAN to another VLAN. Frames will not be discarded across VLANs
because packets are routed across VLANs. This command only works on layer 2 traffic.
Examples
clear mac address-table static
Related Commands
show mac address-table
C613-50007-01 REV B
<port> [vlan <vid>]
<port> [vlan <vid>]
Description
The destination MAC address in HHHH.HHHH.HHHH format.
The port to display information about. The port may be a switch port (e.g.,
port1.1.4), a static channel group (e.g., sa3), or an LACP channel group
(e.g., po4).
The VLAN ID. If you do not specify a VLAN, its value defaults to vlan 1.
awplus# configure terminal
awplus(config)# mac address-table static 2222.2222.2222 forward
interface port1.1.4 vlan 3
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
Switching Commands
15.13