Tunnel Mode Ipv6Ip - Allied Telesis SwitchBlade x908 Series Software Reference Manual

IPv6to4 Tunneling Commands

tunnel mode ipv6ip

tunnel mode ipv6ip Command
Use this command to specify the IPv6 transition tunnel mode. In AlliedWare Plus
5.3.1, 6to4 automatic tunneling is the only tunnel mode supported.
Use the no parameter to return the mode of the IPv6 transition tunnel to an undefined state.
Syntax
tunnel mode ipv6ip 6to4
no tunnel mode
Parameter
6to4
Interface mode
Mode
This command specifies a tunnel encapsulation mode for IPv6 in IPv4. Currently only 6to4
Usage
automatic tunneling is supported. Future releases may support alternative tunneling modes.
It is a requirement that the mode is set on a tunnel. The tunnel will not be operational until the
tunnel mode has been set using the tunnel mode ipv6ip 6to4 command.
Example
interface tunnel
Related Commands
tunnel dscp
tunnel source
tunnel ttl
27.4
New vs_531 %flag
Description
6to4 automatic tunnel mode.
awplus# configure terminal
awplus(config)# interface tunnel 100
awplus(config-if)# tunnel source 10.10.1.1
awplus (config-if)# tunnel mode ipv6ip
awplus# configure terminal
awplus(config)# interface tunnel 100
awplus(config-if)# tunnel source 10.10.1.1
awplus (config-if)# no tunnel mode
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
IPv6to4 Tunneling Commands Use this command to specify the IPv6 transition tunnel mode.
TM
version
C613-50007-01 REV B