Length - Allied Telesis SwitchBlade x908 Series Software Reference Manual

User Access Commands

length

Use this command to specify the number of rows of output that the device will display before
pausing, for the console or VTY line that you are configuring.
If the output from a command is longer than the length of the line the output will be paused
and the '–More–' prompt allows you to move to the next screen full of data.
A length of 0 will turn off pausing and data will be displayed to the console as long as there is
data to display.
The no parameter restores the length of a line (terminal session) attached to a console port or
to a VTY to its default.
Syntax
length <0-512>
no length
Parameter
<0-512>
Configure Line mode.
Mode
To set the terminal session length on the console to 10 rows, use the command:
Example
To display output to the console continuously, use the command:
service terminal-length
Related Commands
terminal length
5.6
Description
Number of lines on screen. Specify 0 for no pausing.
awplus(config)#
awplus(config-line)#
awplus(config)#
awplus(config-line)#
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
line console 0
length 10
line console 0
length 0
C613-50007-01 REV B