Neighbor Capability Graceful-Restart - Allied Telesis SwitchBlade x908 Series Software Reference Manual

neighbor capability graceful-restart

Use this command to configure the router to advertise the Graceful Restart Capability to the
neighbors.
Use the no parameter with this command to configure router so it does not advertise the
Graceful Restart Capability to its neighbor.
Syntax
neighbor <neighborid> capability graceful-restart
no neighbor <neighborid> capability graceful-restart
Parameter
<neighborid>
Disabled
Default
Router mode and Address Family [ipv4 unicast | ipv4 multicast] mode
Mode
This configuration only indicates BGP speaker has the ability to preserve its forwarding state for
Usage
some address family when BGP restarts.
Use the neighbor capability graceful-restart command to advertise to the neighbor
routers the capability of graceful restart. First specify neighbors remote-as identification
number assigned by the neighbor router.
■
Example
awplus(config-router)#
bgp graceful-restart
Related Commands
C613-50007-01 REV B
Description
{<ip-address>|<tag>}
The address of an IPv4 BGP neighbor, in dotted decimal
<ip-
address>
notation A.B.C.D.
Name of an existing peer-group. For information on how to
<tag>
create peer groups, refer to the
(adding a neighbor) command on page
neighbor remote-as command on page
this parameter is used with a command, the command applies
on all peers in the specified group.
The graceful restart capability is advertised only when the graceful restart capability has
been enabled using the bgp graceful-restart
awplus# configure terminal
awplus(config)# router bgp 10
neighbor 10.10.10.50 capability graceful-restart
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
neighbor peer-group
38.75, and
38.79. When
command.
BGP Commands
38.59