Neighbor Attribute-Unchanged - Allied Telesis SwitchBlade x908 Series Software Reference Manual

neighbor attribute-unchanged

Use this command to advertise unchanged BGP attributes to the specified neighbor.
Use the no parameter with this command to disable this function.
Syntax
neighbor <neighborid> attribute-unchanged {as-path|next-hop|med}
no neighbor <neighborid> attribute-unchanged {as-path|next-hop|med}
Parameter
<neighborid>
as-path
next-hop
med
Router mode and Address Family [ipv4 unicast | ipv4 multicast] mode
Mode
Example
awplus(config-router)#
C613-50007-01 REV B
Description
{<ip-address>|<tag>}
<ip- The address of an IPv4 BGP neighbor, in dotted decimal
address>
notation A.B.C.D.
<tag> Name of an existing peer-group. For information on how to
create peer groups, refer to the
(adding a neighbor) command on page
neighbor remote-as command on page
this parameter is used with a command, the command applies
on all peers in the specified group.
AS path attribute
Next hop attribute
Multi Exit Discriminator
awplus# configure terminal
awplus(config)# router bgp 10
neighbor 10.10.0.75 attribute-unchanged as-path
med
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
BGP Commands
neighbor peer-group
38.75, and
38.79. When
38.57