Show Ipv6 Route - Allied Telesis SwitchBlade x908 Series Software Reference Manual

IPv6 Commands

show ipv6 route

show ipv6 route Command
Use this command to display the IP routing table for a protocol or from a particular table.
To modify the lines displayed, use the | (output modifier token); to save the output to a file,
use the > output redirection token.
Syntax
show ipv6 route [bgp|connected|database|ospf|rip|static|<ipv6-
Parameter
bgp
connected
database
ospf
rip
static
summary
<ipv6-address>
<ipv6-prefix/length>
Exec mode and Privileged Exec mode
Mode
Example
The following is a sample output of this command displaying the IPv6 routing table.
Output
25.14
New vs_531 %flag
address>|<ipv6-addr/prefix-length>)]
Description
Displays only the routes learned from Border Gateway Protocol
(BGP).
Displays only the routes learned from connected interfaces.
Displays only the routing information extracted from the
database.
Displays only the routes learned from Open Shortest Path First
(OSPF).
Displays only the routes learned from Routing Information
Protocol (RIP).
Displays only the static routes you have configured.
Displays summary information from the routing table.
Displays the routes for the specified address in the IP routing
table. The IPv6 address uses the format X:X::X:X/Prefix-Length;
where prefix length represents a decimal number between 0 and
128.
Displays only the routes for the specified IP prefix.
The IPv6 address prefix uses the format X:X::/prefix-length; where
prefix-length is a decimal number between 0 and 128.
awplus# show ipv6 route
IPv6 Routing Table
Codes: C - connected, S - static, R - RIP, O - OSPF, B - BGP
S ::/0 [1/0] via 2001::a:0:0:c0a8:a6, vlan10
C 2001::a:0:0:0:0/64 via ::, vlan10
C 2001::14:0:0:0:0/64 via ::, vlan20
C 2001::1e:0:0:0:0/64 via ::, vlan30
C 2001::28:0:0:0:0/64 via ::, vlan40
C 2001::fa:0:0:0:0/64 via ::, vlan250
C fe80::/64 via ::, vlan250
C fe80::/64 via ::, vlan40
C fe80::/64 via ::, vlan20
C fe80::/64 via ::, vlan10
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
IPv6 Commands This command is used to display the IP routing table for a protocol or from a particular table.
C613-50007-01 REV B