Spanning-Tree Mode; Spanning-Tree Mst Configuration - Allied Telesis SwitchBlade x908 Series Software Reference Manual

spanning-tree mode

Use this command to change the spanning tree protocol mode on the device. This can be
either STP, RSTP, or MSTP.
Syntax
spanning-tree mode {stp|rstp|mstp}
The default mode is RSTP.
Default
With no configuration, the device will have spanning tree enabled, and the spanning tree mode
Usage
will be set to RSTP. Use this command to change the spanning tree protocol mode on the
device.
Global Configuration mode
Mode
To change the spanning tree mode from the default of RSTP to MSTP, use the following
Examples
commands:
awplus(config)#

spanning-tree mst configuration

Use this command to enter the Multiple Spanning Tree Configuration mode.
Syntax
spanning-tree mst configuration
Global Configuration mode
Mode
The following example uses this command to enter MST configuration mode. Note the change
Examples
in the command prompt.
awplus(config-mst)#
C613-50007-01 REV B
awplus# configure terminal
spanning-tree mode mstp
awplus# configure terminal
awplus(config)# spanning-tree mst configuration
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
Spanning Tree Commands
19.35