Ip Irdp Holdtime - Allied Telesis SwitchBlade x908 Series Software Reference Manual

IP Addressing and Protocol Commands

ip irdp holdtime

This command sets the maximum length of time that the advertised addresses are to be
considered as valid router addresses by hosts.
The no form sets the holdtime back to the default of 1800 seconds.
Syntax
ip irdp holdtime <0-9000>
no ip irdp holdtime <0-9000>
Parameter
<0-9000>
Interface mode
Mode
The IRDP holdtime is set to 1800 seconds (30 minutes) by default.
Default
To set the holdtime value of addresses advertised on vlan2 to 4000 seconds, use the
Examples
command:
awplus(config-if)#
To set the holdtime value of addresses advertised on vlan2 back to default, use the command:
awplus(config-if)#
show ip irdp interface
Related Commands
23.20
Description
The holdtime value in seconds of addresses advertised.
Default: 1800
awplus# configure terminal
awplus(config)# interface vlan2
ip irdp holdtime 4000
awplus# configure terminal
awplus(config)# interface vlan2
no ip irdp holdtime
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1 C613-50007-01 REV B